A dent in your car may look like a small matter, but it can ruin the appeal of your vehicle and leave the panel sensitive to rust under the auto paint. There are some paintless dent repair “procedures” that drivers attempt on their own, but these struggle more than they do. Know which procedures are myths, so you won’t fall victim to trying them and causing more damage to your car.
While some DIY dent repair may look exciting and appealing at first, it’s not the right way to go for decent dent removal. DIY dent repair is tough to do if you don’t have the specialized training and knowledge to do it, and many DIY techniques don’t work. If you’re considering DIY dent removal or hail damage removal, you might want to reconsider. DIY dent repair methods may bring risk to you and your car.
Here are some DIY methods that you may want to avoid:
Dry Ice
Drivers seldom try engaging their car to heat up in the sun, then putting dry ice over the dent. The drastic change in temperature can make the metal to pop back out. However, this process may cause more damage to the car by cracking or scratching the paint. You will also hurt yourself if you accidentally touch the dry ice or the cold material of the vehicle with your uncovered skin. This process may damage your car’s surface, and fixing that could cost you more than just getting hail damage repair Wheatland or PDR done.
Plunger Pull
The power of a plunger is rumored to be able to pull out dents, but beware if you try this method, because that is not the case. Plunger suction can increase dents, bending the metal as the plunger is pushed down. Some try using a cup plunger, forming a seal by getting both the plunger and the car wet. They then push and pull on the part until the dent pops out. It often ends in overpulling, which pulls the dent from inside to outside. It loosens the paint and breaks the integrity of the metal by overdoing it. Hail Damage Repair Laramie or PDR Technicians have the proper tool to use for the type of dents in your car.
Hair Dryer
Another way is to heat the dent utilizing a hairdryer, then spray it with compressed air to pop it back. Just like dry ice, this process is likely to damage the paint. Once the paint has been damaged, moisture can get into rust the panel, and the entire panel will have to be replaced or repainted. Some think heating up will make the metal flexible and, therefore, will be able to put it back in place. Hairdryers don’t give high enough heat for this, and if they did, it would be dangerous for a person to use it.
You can do all the preparation fixing it yourself, but sometimes DIYing your way through it doesn’t work. Either the dent doesn’t change at all, or you go over and make the dent bubble out the other side of the car. Some DIY kits come with shaping tools that are supposed to keep that from happening, but popping the dent out the other side of the car is so easy, you probably won’t even see you are doing it until it is too late. Once the dent is pulled out the wrong way, it’s much harder to fix.
The only truly reliable and safe solution for paintless dent repair is to take it into a professional. Hail Damage Repair Cheyenne, Paintless Dent Removal technicians have the best skills and the most useful tools to remove dents correctly, and their services are available at Cheyenne, Laramie, and Wheatland. Wyo Dent Co, is an affordable and timely way to fix your dents, and it doesn’t come with the dilemmas of at-home dent repair. They have innovative tools and proper training to restore the panel without damaging the metal or paint.
When you choose Wyo Dent Co, you choose reliability and friendly service. If you are looking for experience, you are in the right place.